5
http://zhyk.en.aliaba.com
Press the FUNCTION button and push the right stick to the left/right at the same time, the corresponding
feeding bin will open. Keep push the stick to release the hook.
Press FUNCTION button and pull down the right stick altogether to turn on/off the fishing light.
Pull down the right stick to turn on/off the front light.
The remote control display also indicates the feeding bin status.
The remote control has two working modes:
Fish detection mode; GPS mode.
The original state mode
：
Is fish detection.
Press the UP key to enter the Press the DOWN key to
fish detection mode
enter the GPS mode
Turn on both bait boat switches, the signal light will be solid. If the remote control is not turned on, the
signal lights will flash. Once the bait boat receives the remote control signal with same ID, the signal light
will change to the corresponding status. If the connection is not successful, the remote LCD will show a
demo picture for 30 seconds. If the connection is established, the LCD will show water temperature and
depth on its left. When the depth is 0, it means the sonar cannot detect the water depth(the possible
cause may be either no deeper than 1 meter, or too deep to detect. Maybe the sonar sensitivity setting is
too low).
Each mode has its corresponding parameter setting
Fish detection:
Press SET button under the fish detection mode to enter the fish detection setting page.
Once the parameters are set, the user must press SET button again to save the modifies.
Backlight switch:
Press + or - button to turn it on or off.
Press the DOWN key to enter the next parameter.
Factory check mode:
Please ignore it.
Press the DOWN key to enter the next parameter
.
Summary of Contents for JABO-5CG
Page 12: ...12 http zhyk en aliaba com...
