JABO 2AG, User Manual, Page: 10 / 14

10
correct the slight yaw caused by the discreteness of the power system. It is not suitable for
adjusting the severe yaw caused by mechanical faults. Mechanical system can be completed.
3 Pay attention to the following points when operating the bait bin
* The bait silo is driven by the motor gear box. Do not try to manually lift the bait silo.
This will cause damage to the mechanical structure of the bait silo.
* Note that the automatic stopping of the bait silo is due to magnets placed on the bottom of the
front end of the bait silo. A magnetic sensor is installed on the hatch cover. Only when the bait
silo is in place, the magnet triggers the magnetic sensor and the bait silo can stop and return to
the normal position.
* It is recommended that the user apply some lubricant to the screw, which will greatly improve
the performance of the skip and extend the life of the screw.
4.Charger use and precautions:
The JABO Lithium series bait boat has a lithium battery charge management circuit installed
in the boat. Please pay special attention to the use of the original power adapter for charging.
Otherwise there are unpredictable security risks! The adapter output is DC 5V / 2A.
Insert the adapter with the boat on the 110v~220v AC power outlet, take off the circular
waterproof cap on the upper part of the cabin, turn off the power switch of the dock, and plug
the adapter's DC output cable into the bay. In the DC charging stand covered, the charging
indicator next to the docking ship's charging stand lights up to show that red is charging. When
the battery is full, the indicator light is green. When the adapter's DC plug is pulled out, the
charging indicator light goes out. Generally, the charging time for a 10A battery is about 14-16
hours. The battery life is about 2.5-3 hours after the battery is fully charged.
Note: When the power battery is not connected to the circuit, after the charging DC plug is
connected, the charging indicator will show as green.
When the boat battery low battery alarm, please return the boat to the shore within 10
minutes and charge in time. Otherwise, the bait boat will risk losing control because the battery
voltage is too low
The remote control is equipped with a lithium battery when it leaves the factory. When the remote
control is low in power, you can use the charging cable provided with the ship to plug in the
mobile phone charger to charge the remote control. The charging port of the remote control is on
the back, and the general charging time is 1.5-2 hours.When charging, the horizontal bar on the
remote control screen starts to scroll, and the 3 horizontal bars no longer scroll when it is full, and
the display is full.
Precautions:
1 Before each use, charge lithium batteries inside the dock to ensure that the batteries are full.