![background image](http://html1.mh-extra.com/html/jabiru/j120/j120_technical-manual_3130523094.webp)
Aircraft Service Manual
Jabiru Aircraft
Pty Ltd
JTM001-1
J120, J160, J170, J200/J400, J230/J430, J250/J450 Variants
REVISION
1
Dated: Nov 2011
Issued By: SW
Page: 94 of 233
Note: “straight” legs are “handed” – ensure the legs are installed on the correct side of the
aircraft.
5.
Bolt the stub axle & calliper mount plate to the main undercarriage leg.
Torque to “solid laminate”
value give in Table 1. Note that if a new leg is being fitted it will be necessary to check and
adjust the angle of the stub axle. This must be carried out in accordance with Section 4.18.
6.
Fit brake caliper to brake mount plate.
7.
Assemble the wheel and brake assembly. Fit the axle extension and adjust the brakes.
8.
Fasten the brake line to the undercarriage leg using zip ties (2 min per leg).
8.8.4 INSPECTION AND REPAIR
1.
Inspect composite beam for damage indicated by cracks or de-lamination. Pay particular
attention to the area around the centre bend and to areas around drilled holes.
2.
When inspecting the legs shown in Figure 61 pay particular attention to the area around each
bend in the leg. Note that it is possible for this leg type to have internal damage which does not
show to the surface. In this case the best indicator of the damage is that the damaged leg will
have lost stiffness compared to the other side and so the aircraft will lean in the direction of the
damaged leg. If required, legs can be returned to Jabiru Aircraft for testing.
3.
Inspect bolts and nuts for signs of stress, bending or corrosion
– replace if in any doubt.
4.
Inspect clamp for damage.
5.
Inspect bolt seats in fuselage for signs of damage, wear or perishing.
6.
For the leg shown in Figure 61, inspect the outboard clamp flock bed & re-flock if damaged.
WARNING
Repairs to the composite undercarriage beams must be referred to JABIRU AIRCRAFT Pty Ltd or
our local approved agent.
8.9
TROUBLE SHOOTING
– MAIN UNDERCARRIAGE
Table 10
– Trouble Shooting – Main Undercarriage
Trouble
Probable Cause
Remedy
Aircraft leans to one side
Incorrect tyre inflation
Inflate to pressure shown at
above
Landing gear attaching parts not
tight
Tighten loose parts. Replace
defective parts.
Leg de-lamination
Install new part(s)
Tyres wear excessively
Incorrect tyre inflation
Inflate to pressure shown in
above
Main wheels out of alignment
Align as specified above
Leg de-lamination
Install new part (s)
Dragging Brakes
Refer to Section 8