INSTRUCTION MANUAL CODE 80359 REV 0
May 2019 (It can be modified without notice)
Page: 43
J
.P. SELECTA s.a.u.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
e-mail: [email protected] - website: www.grupo-selecta.com
11. Problems & Troubleshooting
Failure
Cause
Troubleshooting
There is no power
in the equipment
No electricity supply
Check the power source
Fusion of protective tube
Change the protective tube
Switch power supply failure
Change the switch
Circuit board failure
Contact SAT
N o d i s p l a y o r
temperature error
Display panel failure
Replace the display panel
The display panel cables fall
Fix the connection cables
Short circuit or open sensor
circuit
Check if the seals have loosened:
if loose, re-weld. If not, you must
replace the sensor
Speed is not
shown or there is
no rotation
Engine failure
Contact SAT
Circuit board failure
Slow-running rotary switch out
of service
Replace the slow-motion switch
Speed control key out of service Replace the speed control knob
Abnormal noise
Insensitive rotation of the stirring
blades
Reassemble
Engine failure
Contact SAT
Debris inside the container
Check and clean them
Pressure leakage
and low vacuum
degree
Glasses installed and mounted
with holes
Reassemble
Abrasion of the sealing ring
Replace the sealing gasket
Improper installation of the
sealing gasket
Reassemble the gasket
Aging of the vacuum hose
Replace the vacuum hose
