IZUMI Vidan IZF-V85, Manual

Page: 29 / 80

27
IZF-V85
English
1
Remove the cap while pushing
the convex parts of it inward.
2
Push the power switch to oper-
ate the shaver.
When the travel lock lamp lights up by
pressing the power switch, press and hold
the power switch for 3 seconds or more to
operate the shaver.
3
Pressing the power switch again
during operation sets the shaver
to the turbo mode.
¡
The TURBO lamp (blue) turns on. The
turbo mode drives the shaver faster than
the normal mode.
4
Bring the outer foil in gentle contact
with the skin at a right angle (refer-
ence value: approx. 400
g
), stretch
the skin and move the shaver gently
upwards against the grain.
¡
While shaving, take care not to push the
outer foil too strongly against the skin
(reference value: more than 800 g ). Oth-
erwise, the outer foil will wear at a higher
rate, and become dull or damaged.
¡
To shave delicate parts like the chin,
pull up the slack of the skin by hand,
and stroke upwards. When shaving the
throat, lift the face upwards to thrust the
throat out to pull the slack upwards.
HOW TO USE (continued)
Cap
Power switch
(Lock switch)
2
1
5
4
TURBO
ターボ
ランプ
TURBO
lamp
5
After use, turn off the power switch, and clean the shaver
with the accessory brush. To protect the blades, be sure to
put the cap on after cleaning.
The remaining battery amount is indicated for approx. 7 seconds after turning off
the power.
Note : The shaver can be used to shave with soap or shaving foam. After every use
with soap or shaving foam, be sure to wash the shaver in water.