33
IZF-V86
English
1
Insert the blade of a flatblade
screwdriver into the front panel
to pry it up as shown in the illus-
tration.
2
Loosen and remove the 3 screws
with a Phillips screwdriver, and
open the bode case. (See the
illustration.)
3
Pull out the printed circuit board
on which a rechargeable battery
is mounted.
4
Cut the 2 lead wires with nippers.
5
Cut the terminals at the both sides
of the rechargeable battery with
nippers.
6
Remove the rechargeable battery.
7
Insulate the terminals of the
removed rechargeable battery
with vinyl tape.
Front panel
Printed circuit board
Rechargeable
battery (rear side
of the PCB)
Power supply .....................................Rechargeable battery/AC power supply
Blade motion
Inner blade/First catch trimmer ....Reciprocating
Rated voltage......................................AC 100 V – 240 V
Rated frequency..................................50/60 Hz
Rated capacity ....................................7 W
Standard recharging time ...................2 housr
Battery ................................................Li-ion cell (enclosed type), 1 pc.
Weight ................................................197
g
How to remove the Li-ion battery
¡
The appliance must be disconnected from the supply mains removing the battery.
¡
Turn on the power switch, and run the shaver until the inner blade stops moving. If the shaver is
disassembled before the recharged electricity is depleted, it may catch fire or cause burns.
¡
Follow the procedure below to disassemble the shaver with a screwdriver.
Note
: The battery is to be disposed of safety.
FOR RECYCLING THE Li-ion BATTERY (continued)
SPECIFICATIONS
1
2
3
7
