4
1.2 Installation instructions
1.
The C110MC can be installed on top of the indoor fan coil unit.
2.
Do not run the blue network cables alongside 240 Volt wiring.
3.
When installing network cables down wall cavities or chasing network cables into walls, tape up and protect the RJ45 connector to avoid
damage to the connectors.
4.
Always install zones in consecutive ports starting at Zone 1. The back of the C110MC is marked with the zone port numbers.
5.
Do not directly hardwire the CT24AC into the AC unit’s power supply. This may void the warranty as it will require an electrician in the
event that repair of the iZone 110 system is required.
6.
Connect Zone Damper Actuators (CZDA) to the zone ports using the RJ11 cables as shown.
7.
Connect the Wall controller(s) (C110WC) to the C110WC ports using the RJ45 cables.
8.
Only connect the power supply to the CT24AC port after all components have been connected.
