UM028301-0317
Connect the F64XX Series Development Board to
Z8 Encore! XP
®
F64XX Series Development Kit
User Manual
5
Connect the F64XX Series Development Board to your PC
Observe the following procedure to connect the F64XX Series Development Board to
your PC.
Disconnect or turn off the power to the F64XX Series Development Board before con-
necting or disconnecting the USB SmartCable.
1. Connect one end of the 6-circuit ribbon cable provided in your Kit to the USB Smart-
Cable unit, ensuring that the ribbon’s male connector is aligned correctly with the
female connector on the unit, as indicated by the red stripe in Figure 2.
2. Connect the other end of the ribbon cable to Debug Connector J3 on the Development
Board. Ensure that Pin 1 on the ribbon cable is aligned with Pin 1 on the target con-
nector, as highlighted in Figure 3.
Figure 2. Connecting the 6-Circuit Ribbon Cable to the USB SmartCable
Caution:
