Configuration
3.1.2 Connection to ground for measuring purposes
There is a connection on the PC-I 04/PCI for a ground pin. The abbreviation GND
is marked on the board next to the drill hole.
3.2 Design of the CAN-plugs
Two isolated high-speed bus attachments according to ISO 11898-2 can be
mounted on the interface.
The signals of the first bus connection are connected to the 9-pin Sub-D-plug/-
socket X1/X2.
If the second bus connection is printed, the signals for the CAN-bus of the sec-
ond bus connection are connected to the header X3 and a separate slot plate
with two sub-D9-plugs are supplied with the interface for the bus connection of
the second CAN-controller. This slot plate is connected to the header of the inter-
face via a 9-pin ribbon cable.
3.3 Pin
assignment
The following plugs are present on the interface:
Pin Designation
CAN1
X1, X2
CAN2
X3
3.3.1 Connecting the bus
Signals of the
first bus connection
to the 9-pin plug X1 and the 9-pin bush X2.
Pin no. X1/X2
Signal name
1
2 CAN
Low
3 GND
(JP3)
4
5
6 GND
(JP5)
7 CAN
High
8
9 VCC
(JP4)
-
Copyright IXXAT Automation GmbH
PC-I 04/PCI-Manual, Version 1.2
10
Summary of Contents for PC-I 04/PCI
Page 4: ......
