Remote control
At the prompt > in the terminal program, enter the character string
wt
to start
the wiring test. Then the familiar test instructions appear in the window of the
terminal program. When you have followed the test instructions, please press the
ENTER key on the PC.
During the measurement, a message appears in the window of the terminal pro-
gram. After the measurement the test result appears in the window of the termi-
nal program.
In an automated test run, of course, the character strings
wt
and ENTER must be
issued by a program. In addition, the program must accept the messages and the
test result. With operation via the terminal program, however, it was shown that
the CANcheck supports a serial protocol for the automated wiring test.
In addition, the deletion of all results is supported via remote control. Please press
the ENTER key on the PC to confirm deletion. Please enter the character
\
to can-
cel.
The settings "Language" and "Scan time" can also be carried out by remote con-
trol.
At the prompt > in the terminal program, enter the character string
stop
to end
the remote control server.
Then the system menu appears again in the display of the CANcheck.
Copyright IXXAT Automation GmbH
CANcheck Manual, Version 1.2
66
