Leg Extension Assembly
(IF APPLICABLE)
NO TOOLS REQUIRED:
STEP 1:
Tilt or hoist the core unit assembly
off the ground. Now the leg extensions can be
attached.
STEP 2:
Slide the leg extension around the
three legs of the Machine core unit assembly
and above the bottom flange ring.
STEP 3:
Slide the leg extension up snug
against the leg to allow two pins to be inserted
through the holes of the leg extension.
STEP 4:
Fasten the leg extension to the Core
unit assembly using a set of two 5/16 inch x 2
inch (8mm x 51mm) clevis pins.
STEP 5:
Secure both pins using two hair pins.
STEP 6:
Repeat steps 2 through 5 for each leg
extension.
NOTE:
Once the leg extensions are attached
and secure, the leg extensions act as a tri-pod in
which the Machine can rest on.
Sliding Leg Extension Around Bottom
Leg Of Machine Core Unit
Attaching Leg Extension With a Clevis Pin.
Securing Clevis Pins
Secured with Hair pIns
© 2020 Ixom | www.medoraco.com | 866 - 437 - 8076 | [email protected]
Equipment Assembly
10155_20200529
O&M_GF10000_10492_20201020 - 18
