![IWILL XA100 Ultra ATA-2 User Manual Download Page 40](http://html1.mh-extra.com/html/iwill/xa100-ultra-ata-2/xa100-ultra-ata-2_user-manual_2098655040.webp)
40
Floppy
System will boot from floppy drive
ARMD-FDD / ARMD HDD
LS-120 or ZIP drive, master IDE disk drive on primary channel
CDROM
Boot from ATAPI CDROM drive
SCSI
Boot from SCSI drive.
Network
Boot from Network.
Try Other Boot Devices
Set this option to Yes to instruct AMIBIOS to attempt to boot from any other drive in the system if
it cannot find a boot drive among the drives specified in the 1
st
Boot Device, 2
nd
Boot Device, 3
rd
Boot Device, and 4
th
Boot Device options.
Quick Boot
Set this option to Enabled to instruct AMIBIOS to boot quickly when the computer is powered on.
This option replaces the old Above 1 MB Memory Test Advanced Setup option. The settings are:
Setting
Description
Disabled
AMIBIOS test all system memory. AMIBIOS waits up to 40 seconds for a
READY signal from the IDE hard disk drive. AMIBIOS waits for .5 seconds
after sending a RESET signal to the IDE drive to allow the IDE drive time to get
ready again. AMIBIOS checks for a <Del> key press and runs AMIBIOS Setup
if the key has been pressed.
Enabled
AMIBIOS does not test system memory above 1 MB.
AMIBIOS does not wait up to 40 seconds for a READY signal from the IDE
hard disk drive. If a READY signal is not received immediately from the IDE
drive, AMIBIOS does not configure that drive. AMIBIOS does not wait for .5
seconds after sending a RESET signal to the IDE drive to allow the IDE drive
time to get ready again.
You cannot run AMIBIOS Setup at system boot, because there is no delay for
the Hit <Del> to run Setup message.