IWILL H4204 Series, Hardware Installation Manual

Page: 35 / 64

35
IMPORTANT
IWILL
®
always recommends our customers use EPS12V Power supplies. For any power damaged,
please contact your retailer or IWILL
®
technicians. H4204 SERIES provides up to 700W from the power
supply. This will support most hard drive and peripheral configurations. Always connect all power
supply connectors to the motherboard (one 24-pin connector, two 8-pin connectors, one -12V
connector, and one 10-pin connector) on main board and I/O board.
4-8 Install Expansion Cards
WARNING
Please power off your power supply completely when adding removing any expansion card or other
system components. Failure to do so may cause severe damage to both your motherboard and
expansion card.
4-8.1 Expansion Card Installation Procedure
Read the documentation for your expansion card and make any necessary hardware or software
setting changes such any jumper configuration.
1.
Remove the bracket plate on the slot you intend to use. Keep the bracket for possible future
use.
2.
Carefully align the card's connectors and press with the riser card firmly.
3.
Secure the card on the slot with the screw you removed above.