13
Chapter 1
Quick Installation
Several easy installation steps will be described in this chapter to help the experienced users with
quick installation. If you are a beginner or need to know more about this product, refer to the
Chapter 2.
Step 1. Install retention mechanism and Pentium II processor
There are two sets of the thread studs that need to be screwed to the Slot 1’s retention mechanism
with a criss-cross screwdriver. Insert the Pentium II processor along the retention mechanism in
vertical direction down to Slot 1 connector. Make sure that they are connected thoroughly.
Step 2. Install processor fan
Attach the processor cooler’s power cable to the header marked “J17” and / or “J20”.
Step 3. Select the processor frequency
JP2 is used to select the processor frequency. Simply place one jumper cap onto the speed number
according to the internal frequency you see on your processor. For example: select 333 for a
Pentium II processor 333 MHz.
Step 4. Install the memory module
At least one piece of 168-pin 3.3V unbuffered SDRAM or EDO/FPM DIMM is needed to be
located into the DIMM sockets.
Step 5. Connect the internal peripherals
The internal peripherals means devices that are in the computer chassis like the floppy disk drive,
hard disk drive, CD-ROM drive …
etc. There are one 34-pin flat cable for floppy disk drive and
one 40-pin flat cable for IDE devices included in your retail package. The protected key on
cables’ connector will guide you the correct direction when you insert the cables.
