iWeld GORILLA POCKETMIG 235 DP, User Manual

Page: 140 / 162

EN
4. OPERATION
4.1 Front panel
A – display
The display shows the names and values of the parameters, the numbers of the sets of settings
saved in the memory and the error codes.
BU The voltage (arc length) of the base current. Only for the D-PULSE MIG
method. Adjustment range: -50 - 50%.
Burn Wire burning - the time for which the wire feed continues after the arc is
extinguished.
Cur Adjustment range: -50 - 50% of the factory settings.
Duty Pulse width - pulse duration, allows you to adjust the depth of penetration.
The increase in width increases the depth of penetration, the reduction
limits the amount of heat introduced into the material, reducing the risk of
burning thinner sheets or smaller elements.
Lower pulse width values should be used for higher currents. A larger pulse
width should be used for small currents, for example a width above 50%
should be used for currents below 100A.
Only for the D-PULSE MIG, PULSE TIG and PULSE MMA methods.
Adjustment range: PULSE TIG, PULSE MMA: 5 - 95%; D-PULSE MIG: 20 - 80%.
EndI Final current (crater fi lling)
Only for the MIG/MAG method in S2T and S4T modes.
The adjustment range depends on the type of welded material and wire
diameter.
Endt The duration of the fi nal current (crater fi lling). Only for the MIG method in
S2T mode
Adjustment range: 0 - 50 s
A
V
10