iWeld GORILLA POCKETMIG 225 SYNERGIC, User Manual

Page: 57 / 68

HU
EN
Press the Right button (4) again to adjust the inductance of the welding arc. Use the Right Knob
(3) to adjust the inductance from -10 (less inductance) to +10 (more inductance).
A quick note regarding inductance – this
effectively adjusts the intensity of the
welding arc. inductance makes the arc
‘softer’, with less weld spatter. Higher
inductance gives a stronger driving arc
which can increase penetration. Opti -
mum inductance settings are affected
by many welding variables such as:
material type, shielding gas joint type,
welding amperage, wire size.
The default value of inductance is 10, it is recommended to keep this value unless the operator is
an experienced welder.
- Press the Right Button (4) again to return to the main wires peed/voltage adjustment screen.
If the control panel is not adjusted after 5 seconds it will also return to the primary MIG adjust -
ment mode. Or press the Left/Right (1)/(3) to return to the primary MIG adjustment mode
directly.
- During welding the screen display will change to show the actual welding voltage and welding
current as pictured below
2T/4T function: press the Right Button (4) ,2T/4T Selection Switch to move between 2T and 4T
modes. 4T operation means the trigger is pulled once to start welding and pulled again to stop.
This is useful for long weld joints. 2T mode, the trigger must be depressed and held during weld -
ing.
9