iWeld 800TIG3200ACDCMW, User Manual

Page: 81 / 98

HU
EN
3.3 HF/LIFT TIG display introduction
1. Welding mode button Press it to enter HF TIG or Lift TIG welding mode.
2. Output waveform button Press it to select DC output or AC wave output.
3. Trigger mode button: Press it to select 2T or 4T trigger mode.
4. Welding function button Press it to select No Pulse/ Pulse/ Spot welding function.
(Here is no Spot function in Lift TIG welding mode.)
5. Parameter “A” button Press it to select AC Balance. Setting range: -5 to +5.
6. Parameter “B” button Press it to select AC Frequency. Setting range:
50~250Hz.
7. Function “A” button Press it to select Pre-gas time, Start arc current and Up
slope time.
8. Function “B” button Press it to select Down slope time, End arc current and
Post-gas time.
9. Parameters select/adjust
knob:
Press it to select welding current and other param-
eters. Rotate it to adjust parameters’ value.
10. Current display It displays welding current during welding operation,
otherwise show current selected.
11. Welding voltage display It displays welding voltage.
12. Cooling mode selecting
button
Press it to select Water Cooling.
11