iWave-F Modification Instructions:
When the iWave-F is too long for the coil which it’s being applied, perform the following
steps:
1. Measure how much past the end of the coil the iWave-F lies.
2. Bend the iWave-F back on top of itself (DO NOT bend under with sticky backing
facing each other) so the brush pairs on the top will lay next to the brush pairs on
the bottom, shown in Figure 1.
3. Peel the backing off of the iWave-F and press it down to the cooling coil starting
at the power entry side of the iWave-F. DO NOT press down on the end of the
iWave-F that will need folded to shorten the length. See Figure 2.
4. Fold the iWave-F back to achieve the length required, lining up the bottom and top
layer brush pairs as shown in Figure 1, and place a piece of electrical tape across
the joint. See Figure 3.
5. Continue to use electrical tape down the iWave-F towards the end, making sure
that the tape joints are between the brush pairs. DO NOT allow the tape to cover
the brush pairs. See Figure 4.
6. DO NOT crease the end of the iWave-F flat. As a guide, use a #2 Phillips screwdriver
inside the fold joint to ensure the proper bend is achieved. See Figure 5.
7. Once the iWave-F has been folded and taped to the length required, push it down
on the coil.
8. A successful fold procedure will create “pockets” for the carbon fiber brushes to
emit the ions.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Typical Location Install on Ductless Wall System:
Figure 6
Affix iWave-F power
pack to back of cabinet.
Affix iWave-F to the top of coil on plastic strip (or top
of fins) to treat coil, blower and living space.
2008 Altom Ct. • St. Louis, MO 63146 • 800-554-5499 • www.nucalgon.com
Calgon is a licensed trade name • (1017) 4-420
110/120 VAC Power
iWave-F
wire
nut
BLACK WIRE (HOT)
Voltage Input
Neutral
WHITE WIRE
RED WIRE
(Not in Use)
208/240 VAC Power
iWave-F
wire
nut
RED WIRE (HOT)
Voltage Input
Voltage Input
WHITE WIRE (HOT)
BLACK WIRE
(Not in Use)
*tape wire to
signify it is Hot.
NOTE: For best results, power
continually. From time-to-time,
lint/dust must be brushed off
the iWave-F emitters with a
soft bristle brush.
Cleaning:
If required, use a wet wipe or damp cloth to clean the
ionizer bar. A soft bristle brush, like toothbrush, can also be used
to clean debris from ion emitters. Do not expose the iWave-F to
corrosive cleaners. Contact Nu-Calgon for further guidance with
coil cleaner options.
Limited Warranty:
The iWave-F is warranted for three years and covers any defects in
material or workmanship under normal use. If during the warranty
period a claim is made, the product will be replaced. GPS’ warranty
does not cover labor, return shipping charges, damage from
connecting the unit to the wrong voltage, or improper iWave-F
installation in system. See GPS’ standard warranty, terms and
conditions available at www.nucalgon.com for further information.
Contact your local Nu-Calgon account manager with further
questions.
