OPERATION AND PROGRAMMING - 45
De-register Individual Handsets
To remove power from the base unit, unplug
L1
(port 1).
Reposition the dip switches as follows:
Handset 1
– Place switches
1
and
2
in the down position (
On
)
and switch
3
in the up position (
Off
).
Handset 2
– Place switch
1
in the down position (
On
) and
switches
2
and
3
in the up position (
Off
).
De-register Handset 1 De-register Handset 2
Restore power to the base unit. During the de-registration process
the LED on the base unit will flash at a unique rate; 125
milliseconds on, 125 milliseconds off. The de-registration process
will take approximately five seconds.
When the process is complete, remove power from the base unit by
unplugging
L1
(port 1). Place the dipswitches back into the
Normal Operation
mode, by placing all switches up or off
position.
Because the de-registration process is initiated from the base unit,
the handset remains passive and will update once the de-registration
process is complete. To confirm that the de-registration process is
successful, the de-registered handset(s) will display:
> PLEASE
REGISTER!
Summary of Contents for OM-8WRLS
