background image

4

 Installing canister 

Install a canister following the procedure below.

Be aware that if a canister is installed incorrectly, unexpected dangers may result.

  Make sure that there is no source of ignition nearby.

  Turn the knob towards the minus (-) symbol direction 

all the way and make sure that it is closed.

  Remove the canister cap of the canister.

  Make sure that the guide (protrusion) is in the 

correct guide position.

 Caution

Install the canister 

correctly

If the canister is installed 

tilted, liquid gas may enter the 

main unit, which may cause 

the flame to become larger 

during ignition. Install the 

canister horizontally.

Do not twist with 

excessive force when 

attaching or removing a 

canister

Excessive force will damage 

the canister holder.

When it is difficult to install the canister 

(because force is required), apply a thin 

coat of vegetable oil to the tip of the 

canister (Part   in the illustration below).

Application location for 

vegetable oil

Canister 

holder

Guide

(Protrusion)

O ring (seal)

 Correct guide position

(When installing/removing the canister)

 If the guide (protrusion) is in the wrong position,

  the canister cannot be installed. 

Canister notch

Guide (Protrusion)

Canister holder

A

B

Knob

  Align the guide (protrusion) of canister holder with 

the canister notch of canister. Turn the canister in 

the direction 

B

 around 45 degree,  while pushing 

the canister to the direction 

A

.

  Make sure that the canister is installed correctly. 

(The guide (protrusion) is upper position) 

● After installing the canister, if you discover a hissing 

sound from the attachment point indicating gas 

leakage or smell gas, remove the canister. Remove 

any dust attached to the joint if present, and re-install 

the canister.

With canister attached

Notice

The following canisters can be used with this product:  

Iwatani Butane Fuel and FORE WINDS Butane Fuel.  

Because of the difference of the outer diameter of the canister, a slight amount 

of rattling occurs on tables and other flat surfaces, but this does not indicate a 

malfunction.

  Always use a fuel canister labeled as “Iwatani Butane Fuel” or “FORE WINDS Butane Fuel”

Summary of Contents for Fore Winds FW-CS01











Reviews: