IVT OS-150, Instruction Manual

Page: 15 / 76

15
Instruction manual
EN
cool by running for approx. 3 minutes at maximum speed with
no load.
Operating instructions
Place tool with entire sanding face in contact with •
workpiece.
Switch on tool and guide it in broad circular movements •
over surface to be sanded.
Do not apply additional pressure to tool when sanding, the •
tool is usually heavy enough itself to guarantee optimum speed
and good finish.
WARNING
Do not tilt! Sand in several stages, using a finer grain size each
time.
Maintenance and storage
CAUTION
Before any work on the machine itself, pull the mains plug.
Always keep the tool and the ventilation slots (if present) •
cleaned. Regular cleaning and maintenance of the appliance
will ensure efficiency and prolong the life of your tool.
If the tool should fail despite the rigorous manufacturing •
and testing procedures, the repair should be carried out by an
authorized IVT customer service.
Keep all nuts, bolts, and screws tight, to be sure the tool is in •
safe working condition.
Replace worn or damaged parts for safety. •
Use only original spare parts. Parts not produced by •
manufacturer may cause poor fit and possible injury.
Store the tool in a dry room out of reach of kids and away •
from any flammable material.
Never wet the device or spray water on it! •
Use only mild soap and a slightly damp cloth to clean the •
sander. Many household cleaners contain chemicals which could
seriously damage the plastic. Do not use petrol, turpentine,
lacquer, paint thinners or similar products.
Environmental protection
Recycle raw materials instead of disposing as
waste.
Tool, accessories and packaging should be sorted for
environment-friendly recycling.
The plastic components are labelled for categorized recycling.
These instructions are printed on recycled paper manufactured
without chlorine.