30
6.4.16 USB printer
Each USB-PCL printer can be used to printout the protocol. If a USB-
PCL printer is connected to the furnace, the necessary software
driver is loaded. After that, the USB printer is immediately ready for
use.
–
The status of the USB-PCL printer is shown in the "Information"
menu item
–
The desired protocol to be printed can be selected in the
protocol table.
6.4.17 USB memory stick
Most USB memory sticks may be used to store programs. For that
purpose, the USB memory stick must be prepared as an external pro-
gram memory.
Once a prepared USB memory
stick is ready for use, the program
selection screen will show another
touch button for the selection of
the UBS memory stick.
– The active status of the USB
memory stick is shown in the
"Information" menu item
(page 3/3).
– In the Program Manager, the
USB memory stick may now be
selected as either the source
and/or the target.
In this way, a backup copy of all the programs can now be made at
any time.
6.4.18 Timer
The timer can be used to put the
furnace in an energy saving mode
for a defined period of time.
During this time, the heating of
the Programat is deactivated, so
that the power consumption is
only minimal. The furnace itself,
however, remains switched on.
Avoid activating the timer when
the furnace head is open.
Summary of Contents for Programat P700/G2
