Ivoclar Vivadent Programat P700/G2, Operating Instructions Manual

Page: 23 / 40

23
5.5.3 Information
The information pages 1 to 3
provide information on the
current software version,
operating hours, calibration
settings and status of the
identified USB devices, such as
printer and USB memory stick.
The information display also
serves to check whether the
Programat furnace has identified
a USB device.
5.5.4 Calibration
By pressing the "Start calibration
program" touch button, the
program is automatically started.
Please see the notes in
Chapter 7.4.
5.5.5 Special programs
Press the "cogwheel" key,
followed by the touch button
"Special programs".
5.5.5.1 Vacuum pump test program
With this program, the vacuum
performance of the furnace
vacuum system can be auto-
matically tested. For that
purpose, the achieved (mini-
mum) pressure in mbar is mea-
sured and indicated. If the
pressure value is below 80 mbar
(hPa), the vacuum performance
of the system is adequate.
5.5.2.2. Copying programs
By pressing the "Copy
programs" touch button, this
screen is displayed.
Here you can set the source and
the target of the copy procedure.
The desired touch button can be
selected (black frame) by slightly
tapping on it. Subsequently, the
button can be edited using the
+/- keys or the numeric keypad.
If a memory stick is used, an
additional touch button is dis-
played.
This screen is displayed by
pressing the touch button
"Copy". The copy procedure is
executed by pressing the touch
button "Yes, copy".
5.5.2.3 Save the firing program / firing group on the USB
memory stick
The majority of USB memory
sticks can be used as program
memory. In order to use the USB
memory stick as external pro-
gram memory, it has to be first
prepared as a storage medium.
For this purpose, connect the
USB memory stick to the
furnace. Subsequently, select
“Prepare USB memory stick as
external program memory” in the program manager. Select /Hard
Disk…/ and start the procedure with Open. The process is completed
when the message for the successful preparation of the USB memory
stick is shown on the display.
All the existing firing programs
(Ivoclar Vivadent programs or
individual programs) of the
furnace can be saved on a
prepared memory stick. Select
Selection – Program manager –
Copy programs and make a
choice using the +/- keys:
• Program (copy a single
program)
• Group (copy a single group)
• All programs
After a USB memory stick is
ready for use, pressing the Home
key results in the program
selection screen with another
touch button for the selection of
the memory stick being shown
for the selection of the USB
memory stick.