IVC Displays NP-9XX-MA, User Manual

Page: 26 / 100

25
NP-9XX-MA
User Manual
Procedures of CMOS clear:
a) Turn off the system and unplug the power cord from the power outlet.
b) To clear the CMOS settings, use the jumper cap to close pins 1 and 2 for
about 3 seconds then reinstall the jumper clip back to pins open.
c) Power on the system again.
d) When entering the POST screen, press the <ESC> or <DEL> key to enter
CMOS Setup Utility to load optimal defaults.
e) After the above operations, save changes and exit BIOS Setup.
9. BAT2:
(2.0mm Pitch 1x10 Wafer Pin Header), Smart battery Interface.
Pin# Signal Name
Pin1 VCC_BAT1
Pin2 VCC_BAT1
Pin3 VCC_BAT1
Pin4 SMB_DAT_SW
Pin5 SMB_SCL_SW
Pin6 BAT1_TEMP
Pin7 Ground
Pin8 Ground
Pin9 Ground
Pin10 SET_BAT1_ON
Function Specifications
Nominal voltage (3S1P) 11.1~12.6V
Charge voltage 12.6V
Charge current 0.5C
10. BAT_LED:
(2.0mm Pitch 1x4 Wafer Pin Header), The Charge status indicator for BAT2.
Pin1-Pin3: Charge LED status.
Pin2-Pin3: Discharge LED status.
Pin4-Pin3: EC LED status.
Pin# Signal Name