14
5200860 Rev H
Ion-O-Vac
6. PRIOR TO START-UP
To avoid damage to the press, please use the checklist below before starting up the
Ion-O-Vac web and sheet cleaner:
1.
Check Clearances:
Inch the press and check for clearance to the vacuum heads.
For a sheet-fed press, make sure that the gripper bars do not hit the vacuum
head assembly. For Ion-O-Vacs with a manual or pneumatic retraction system,
make sure that the vacuum heads or the drive motor does not interfere with
normal press operation both in retracted or normal position.
2.
Check Seams:
To avoid vacuum loss, check all the seams and make sure that
they are sealed properly.
3.
Check Voltages:
Double check that all power input corresponds to the
nameplates of the collection system, power supplies, drive motors, speed
controls and magnetic starter. Make sure that the overload relay is set at the
appropriate amperage rating.
4.
Check Dampener Settings:
To avoid damage to the collection system, double
check all ducting dampeners to make sure they are open.
Summary of Contents for Simco-Ion Ion-O-Vac
