12
5200860 Rev H
Ion-O-Vac
Install the reset button. Make sure that the reset extension rod does not
unintentionally press the reset button with the cover/door closed causing the
overload relay to be in a continuous automatic mode and does reset the overload
relay when intentionally pressing the button from the front of the enclosure.
Power Supplies
The power supply can be wired separately from the equipment, or a single-phase
voltage can be picked up on the magnetic starter so that the power can be controlled
with the collection System. Make sure that the three-phase voltage matches the
input voltage requirement on the power supply. See Figure 10 and follow the
instructions below:
1. Install the power supply securely. Keep free of dirt, oil and water and keep away
from excessive heat.
2. If the power supply is not grounded through the line cord, connect a 16 GA
copper wire between the ground stud and cold water pipe or a grounded
machine frame. Clean the grounding surface of paint, dirt, etc. (DO NOT
connect to gas or hot water pipe.)
3. Remove dust cap and insert connector until it engages to the high voltage
connector spring. Tighten the screw cap into the high voltage terminal.
4. Connect the line cord to the electrical supply per nameplate specifications
(120V units are supplied with a 3-wire cord and a male plug; 230V units are
supplied with a 3-wire cord with a stripped, tinned lead).
5. For added safety and extended life for those units without an integral power
switch, input voltage to the power supply should be shut off when not in use. If
possible, connect input voltage to the power supply through the machine “ON/
OFF” and/or “RUN” circuit.
Figure 10. Power Supply
Summary of Contents for Simco-Ion Ion-O-Vac
