ITW GSE 4400 Tier 4, Manual

Page: 26 / 126

Operation Manual - ITW GSE 4400 Tier 4
NOTE! – The screens shown in this manual reflect the current software version at the time of
publication. The screens on your unit might differ slightly based on the software version
running on your unit. Any changes will be described in a Service Bulletin which should be
placed in the back of this manual.
Default Screen:
There are two default displays depending on whether the engine is running or not. When the unit
finishes its self-check after first being powered up, the display will show the number of hours the
engine has been operating. After a short delay, the engine hours are replaced with the current time.
This then becomes the default display when engine is off. (The engine operating hours are always
available on the “Engine” information screen.)
During the engine start process, the screen will be modified to show
the current status until the engine is running and the unit is ready to
output power.
Note: If the engine is configured to go to idle until an output is
activated, it will still say it is ready for use. However, the engine will
have to ramp up to 2000 RPM and the voltage stabilized before the
output contactor will close.
When output power is ready, the screen will appear as follows
showing all available outputs:
Both default screens enable the user to quickly have access to other
pertinent information by pressing
▼ or ▲ to cycle through the display
screens below:
The 28V data page will only be displayed if that option is available.
Pressing
◄
will return to the default menu screen.
Unit information is displayed using the Parameter Information icon. To
access the information icon, press the
● from the default menu and hold it down for approximately 5
seconds.
To select a submenu, simply use the navigation keys
◄▼▲► to highlight the icon and then press
the ● to enter the sub-menu.
To leave the Icon Menu highlight the ”Home” icon and press ●
OM2247 Rev B Page 25 of 125