electronic GmbH
Ittermann
electronic
GmbH
Köhlergasse
16-18
D - 99842
Ruhla
Phone:
+49 (0)36929 - 75-0
Fax:
+49 (0)36929 - 75-35
Internet:
www.ittermann.de
E-mail:
Mode level 4
RDM-command “Identify Device” applies
Mode level 5
This mode level processes the control information for the
channels 1 – 8, which are saved in the internal storage, which
contains the figures for this mode level. The content of the
storage can only be changed by RDM-command.
Also the figures can be defined as elusive (available until switch-
off the power supply) or permanent (are available again after
switch-on the power supply). Please look at the RDM-command
“SET NV-Operating-Mode” in Appendix D.
Mode level 6
The figures, which are saved in the internal storage of mode
level 6 and 7, processes just once (single-shot). These figures
are the control information for channels 1 – 4 (colour light c
hannels). They can only by changed by an according
RDM-command.
Mode level 7
The figures, which are saved in the internal storage of mode
level 6 and 7, processes in an infinite loop. These figures are the
control information for channels 1 – 4 (colour light channels).
They can only by changed by an according RDM-command.
Mode levels 200, 201, 203, 204 and 205
These mode levels show information about the DIP-switch
configuration of SW1. They can be read by a RDM-command but not
changed. Please look at the RDM-command “GET NV-Operating-
Mode”.
Instruction Manual iSL 3014
Dated 09th of June 2011
Page 27/31