100P Enclosure 7 Adjustable Pressure Switch
Page i
WARNING
CAUTION
NOTE
Manual No. 610-0006 Rev F
Neo-Dyn
28150 Industry Drive
Valencia, CA 91355
Tel: (661) 295-4000
Fax: (661) 294-1750
World Wide Web: www.neodyn.com
Copyright 2002
ITT
Important Information
The product warranty applicable to this ITT Neo-Dyn
®
instrument
is as stated on page 17 of this manual.
Should any after-delivery problems arise, please contact
ITT Neo-Dyn’s Customer Service using the information above.
Our normal business hours are weekdays, 7:00 am to 3:30 pm,
Pacific Time.
Before installing this Adjustable Pressure Switch, become
familiar with the installation and adjustment instructions in
Chapters 2 and 3.
Indicates a hazard, which can cause severe personal injury,
death, or substantial property damage if the warning is
ignored.
Indicates a hazard, which will or can cause minor personal injury
or property damage if the caution is ignored.
The electrical wiring must be connected to the switch by means of
conduit or flameproof cable gland certified to BS EN 60079-1.
The electrical wiring must be 105 °C rated minimum copper
conductors only. If replacement of the setscrew that secures the
threaded cover of the electronics housing is necessary, it must be
replaced with a 0.138-32 UNC-2A (6-32) Hex Socket Head Cap
Screw, 300 series CRES or CAD Plated Grade 5 Steel.
Indicates additional information about a particular item necessary
to the operation of the unit.
This document contains proprietary information, which is the
property of Neo-Dyn, a unit of ITT Industries. This document
may not be reproduced, either in part or in full, without the
consent of ITT Industries.
SPECIAL
CONDITIONS
FOR SAFE USE