Operation: CP1SD/T/L Version
CENTRON® Polyphase Meter Technical Reference Guide
61
Each SCM message contains tamper information. Below is a chart that indicates the tamper
information available in each SCM:
SCM #
Indicator #
Group
1 1
Meter
Inversion
1 2
Meter
Removal
2
1
Demand Reset (Push Button)
2
2
Low Battery or End of Billing Schedule (1 Year from end)
Warning
3 1
Billing
Events
3 2
Non-Billing
Warnings
Using the PC-PRO+ Advanced programming software, you can:
Configure the quantity(s) to be transmitted
Select the type of registers to be transmitted.
Select the number of digits for the data to be transmitted as well as the number of
decimal place digits for the data.
Select the type of registers to be transmitted.
Select the number of digits for the data to be transmitted as well as the number of
decimal place digits for the data.
Select one of three date formats to be transmitted as ERT information.
Enable TOU and select the TOU rate to be transmitted.
Select whether transmission shall be stopped based on SiteScan
When using Type 8 ERTs the format for the kWH value should be 7.0(XXXXXXX)
and the format for the Demand value should be 7.3 (XXXX.XXX).
SiteScan On-Site Monitoring System
The SiteScan on-site monitoring system consists of the following features:
Meter self-diagnostic checks
Toolbox Mode with its on-site and/or on-line display
SiteScan system and installation diagnostic checks
Diagnostic output alarms
Using the Itron, Inc. PC-PRO+ Advanced Programming software package you can
customize the SiteScan System for each individual metering site. The use of the SiteScan
on-site monitoring system greatly enhances the ability to diagnose and resolve site-specific
metering or tampering problems.
