Section 2, Mounting the WindowWasher
8
WindowWasher Installation Manual
2.2
Your Mounting Location
Your mounting location should consider the following:
•
Mounting location must be able to support double
the gross weight of The WindowWasher™ by ITR
(i.e. 150 lbs. x 2 = 300 lbs/68 KG x 2 = 136 KG)
and must be of a non-combustible surface.
•
The WindowWasher™ by ITR is 14”H x 14”W x
24”D (35.6 cm x 35.6 cm x 60.9 cm). See Figure
2-1: Dimensions.
The WindowWasher™ by ITR must not be installed in any
compartment with flammable gasses.
•
The WindowWasher™ by ITR must be completely
isolated from living spaces. Combustion air must
be drawn from a 100% outside source and cannot
contain any combustible gasses.
•
The WindowWasher™ by ITR must be mounted in
an area that provides unrestricted access to the
front panel mounted fuel and water connections,
and top mounted power and exhaust connection
(minimum of 10” top clearance) and 3” clearance
to all other WindowWasher™ surfaces.
•
The WindowWasher™ by ITR must not be installed
in any compartment with flammable gasses.
•
The WindowWasher™ by ITR must be mounted
horizontal and level using eight (8) x 1/4” through
bolts using 1” diameter washers, lock washers
and nuts.
•
It is recommended that a catch tray be placed
under The WindowWasher™ by ITR for containing
any unexpected leakage.
If The WindowWasher™ by ITR is going to be mounted in
the engine compartment, check for adequate ventilation.
When the engine is running, this area could be under a
negative pressure. Make sure the air intake and exhaust
hoses have no leaks and are well-fastened to the heater,
silencer and through van fitting. Assembly parts that may
cause injury through accidental contact should be
protected.
! CAUTION
NOTICE
