RECEIVER IT3R10
USER MANUAL
7
Standard fastening
5. INSTALLATION AND START-UP
5.1. INSTALLATION OF THE RECEIVER
The receiver should be installed in an accessible location to be able to work on it easily.
Please note in compliance with RD 171/2004 on the Coordination of Business Activities, that you must
guarantee the security conditions for the maintenance of the machine in question, especially in its
accessibility and transit areas up to the points where the operator must do their job.
(1)
¡ATTENTION!:
IT IS VERY IMPORTANT TO CLOSE THE RECEIVER COVER
PROPERLY IN ORDER TO ENSURE ITS WATER TIGHTNESS, SINCE THE INLET OF
WATER CAN DAMAGE IT. THE GUARANTEE DOES NOT COVER THE DAMAGES
CAUSED FROM THE INAPPROPIATE CLOSING OF THE COVER.
In applications with an exterior antenna, it should be free of metal shields in order to achieve a better
radio link and avoid failures in communication.
5.1.1. FASTENING OPTIONS
For the magnetic fastening option, it should be placed on a metal surface with a MINIMUM THICKNESS
of 4 mm, in which the two magnets make contact in all their area with the surface
Due to the magnetic force of the magnets, to dismantle the set, lever with a flat screwdriver between the
metal structure of the machine and the magnetic fastening
¡ATTENTION!:
ONCE INSTALLED, CHECK THAT THE RECEIVER IS FIRMLY
ANCHORED AND IT DOES NOT SLIDE
5.2. CONNECTING
It is recommended to connect the equipment with a standard multi-cable hose. This hose will be
connected to the equipment at one end using the supplied Itowa terminal strip, while a multi-pin connector
will be placed on the other, identical to the one used in the machine to connect it to your conventional
pushbutton box.
1
Only
applicable in Spain
1
2
Magnetic fastening
(optionally)