RECEIVER IT3R10
USER MANUAL
13
9. POSSIBLE INCIDENTS AND SOLUTIONS
INCIDENT
STATE
SOLUTION
The device won't
start
Led S4 of the RX flashes
Eeprom fault. Check in the RX that it is
inserted in its housing. If it is and still
does not work, contact the Technical
Assistance Service
The set is not connected to
the machine
Connect the hose from the receiver to
the electrical panel of the machine
using the corresponding connectors
The set is connected to the
machine but it does not
work
The power supply of the set is under
45% of the nominal value. .
The set starts up
but the machine
does not work.
The set is connected to the
machine but it does not
work
The fuses of the stop relays are blown.
They should be replaced with new
fuses of the same value.
Connect the cable / cabin keypad
instead of the receiver and if the
buttons do not activate the outputs it
can be deduced that the problem is
with the machine.