SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Page 4 of 11
www.itohdenki.com
ITOH DENKI, USA, INC.
135 Stewart Road
Ph: 570.820.8811
Hanover Industrial Estates
Fx: 570.820.8838
Hanover Township, PA 18706
rev13-0314
SPECIFICATIONS
Electrical
24V DC ±10% input
- Battery
- Power Supply: fullwave rectified with smoothed current and <10% Ripple
- Supply should be rated at 5 A or more and should not be effect by peak
current of 20 A for 1 msec.
Power ON delay <1s
4A locking current
Input signal level for activation
- 0V (3V or less) for NPN
- 24V (18V or greater) for PNP
Output (Error and Motor Pulse) signals
- Open collector 24V, 25mA or less
- NPN
- PNP (selectable for Error only)
Servo brake mode
- 0.2s delay between stop signal and servo brake reaction
- 1.0A maximum brake current
- Servo brake is not active with run signal applied or during error conditions
Applicable
PM Models
PM486/500FS
PM486/500/570/605FE
PM486/500FP
PM635FS
Brake
Dynamic (Electric)
Servo (Power Moller holds its position)
Protection
Thermal protection reaction
- 85° C (185° F) on the PCB
- 105° C (221° F) in the motor
Built-in 5A fuse for power supply protection
Built-in diode for incorrect wiring protection
Applicable
Environment
Temperature 0~40° C (32~104° F)
<90% Relative Humidity (No condensation)
No corrosive gas
Vibration <0.5G
