ITM Italia D 15 PV, Operator'S Manual

Page: 13 / 96

4
GB
5
.
START - STOP
5
.1 Start (without environment thermostat)
-Fill the tank with fuel.
-Insert the plug in the mains socket (the red LED comes ON).
-Place the ignition switch to ON (the green LED comes ON and the fan begins operating).
The automatic ignition cycle commences, through the control equipment.
After a few seconds of automatic monitoring, the generator begins operating normally. If the
unit comes to a halt because of minor functional irregularities and the RESET PUSH-BUTTON
LED comes ON, press this button to repeat the ignition cycle.
5 .2 Stop (without environment thermostat)
-Place the main switch to OFF.
-Combustion halts while the fan continues to cool the interior of the generator. During this
stage, fan operation may be continuous or intermittent until complete cooling is achieved, as
measured by the post-cooling thermostat located onboard the boiler.
5
.3 Start (with environment thermostat)
-The unit is pre-set for connection to an environment thermostat (not supplied as standard).
-Connection should be made using the plug on the control panel.
-Having set the environment thermostat, place the switch to
AUT
. To halt the generator,
operate either the main switch or the environment thermostat.
In both cases, the generator undergoes a correct cooling cycle.
When the machine is in normal duty condition the reset button will flash. In case of bad
working, the reset button will stay alight for about 10 sec. Please detect and solve the problem
causing the failure and reset the machine by pressing the button.
(only for SATRONIC DKO
970)
6
.
CLEANING THE TURBO
- The turbo disc is an integral part of the tapered inlet.
- To clean the disc, it must be removed from the support.