RLC-200
DOC-RLC200-MNL Rev8.doc (6/13/2017)
Copyright 1999-2017 ITL, LLC
Page 12
of
15
Configuration Jumpers
The configuration jumpers must be set to match the type of obstruction lights used with
the RLC-200 controller. Jumper settings for typical markers are shown in the figure
below. Contact the factory if your model lights are not shown.
Configuration Switches
SW1 - Configuration Switches
Number Description
Function
1
Transfer Enable
ON – Transfer Enable
OFF – Transfer Disable
2
Transfer Alarm
ON – K7 is Transfer Alarm
OFF – K7 is Mode Relay
3
Not Used
4
Not Used
5
Not Used
6
Marker Type
See Marker Configuration Jumpers above
The factory default setting for all switches is OFF
SW4 - Configuration Switches
Number Description
Function
1
Not Used
2
Not Used
3
Not Used
4
Not Used
* The factory default setting for all switches is OFF
Note: This manual is subject to change without notice. Refer to the diagram in the door
of the RLC-200 or the manual shipped with the RLC-200 for setup and configuration
information.
