8
1. Connect the Videoscope control cable video connector into the Main Videoscope Input connector
located on side of
V5 LE Videoscope System
shown in Fig. 2 above.
2. Connect the second connector, Videoscope control cable Light Input, into Light Source to be used.
White light source has a knob for dimming the light intensity, while each of the IR/Blue light sources has
an illumination attenuation lever to shutter down the light intensity (Fig. 2 & 3). Adjust as needed.
3. If the system will use the internal DC Battery Pack for power, the AC/DC switch on the back of the video
case shown in Fig. 4 must be set to DC position. See Basic Operations section for operation instructions.
4. If AC power is to be used, please connect the AC power supply (included in the kit)
to the system’s AC
input located on the rear panel, see Fig. 4. Ensure that the AC power cord is connected firmly to the AC
inlet of the AC power supply. Next, plug the AC power cord securely into the power outlet and make
sure that the AC/DC switch is set to AC position. See Basic Operations section for operation
instructions.
F
IG
.
4:
R
EAR
P
ANEL
CAUTION:
Reference the power input configuration tag located on the rear panel. Failure to use a
proper cord and voltage supply could result in property damage, personal injury or system
malfunction.
CAUTION:
Inspect the power cord before use. Using a damaged power cord may result in electric
shock.
CAUTION:
The power supply included in the kit is not water proof. Do not use it in wet conditions
where the risk of producing electric shocks increases.