SuperBus 8Z LED Touchpad
Page 2
Installation
The touchpad can be installed on a wall or electrical
gang box, either single- or dual-gang.
Installing the Mounting Plate
1.
Separate the mounting plate from the touchpad by
pressing the tab at the bottom and sliding the
mounting plate down (see Figure 1).
Figure 1. Separating the Touchpad from the
Mounting Plate
2.
Place the mounting plate on the wall and mark the
four mounting holes (see Figure 2). Be sure to
leave a 4¼ inch clearance on the left side to allow
for the Quick Guide slide-out card.
Figure 2. Marking the Mounting Holes
3.
Insert anchors at the marked locations where
studs are not present.
4.
Looking at the back side of the mounting plate,
turn it so the tab is on the left (see A in Figure 3)
and position the Quick Guide slide card into the
slots on back of the mounting plate as shown in
Figure 3 (A). Make sure the card is unfolded and
the ‘Zones’ section is facing you.
5.
Slide the card in the direction of the arrow in Fig-
ure 3 (A) until it snaps into the position shown in
Figure 3 (B).
Figure 3. Inserting the Quick Guide Slide Card
into the Mounting Plate
LIFT AND PULL
MOUNTING
PLATE TAB
8581G07A.DSF
TAB
WALL-MOUNTING HOLES (4)
DUAL-GANG MOUNTING HOLES (4)
SINGLE-GANG
MOUNTING HOLES (2)
8581G02A.DS4
8581G08A.DSF
SWING CARD OVER IN
DIRECTION OF ARROW
UNTIL CARD SNAPS
INTO PLACE
ZO
N
ES
01
__
__
___
02
_
___
__
_
03
_
___
__
_
04
_
___
__
_
05
_
___
__
_
06
_
___
__
_
07
_
___
__
_
08
_
___
__
_
ZO
N
ES
01 _______
02 _______
03 _______
04 _______
05 _______
06 _______
07 _______
08 _______
A
B
