Ithaca ITHERM 280, Programmer'S Manual

Page: 177 / 318

* % 8 %.
#2,
[ESC] y Set control feature commands
ASCII [ESC] y <n>
Hexadecimal 1BH 79H <n>
Decimal <27> <121> <n>
IPCL &%Y0-9 or &%YX <m
1
> <m
2
> <m
3
> (for numbers greater than nine)
EPOS [ESC] y <n>
Where n 0 Reinitializes the printer and forces Citizen mode
1 Reinitializes the printer and forces Star mode
2 Reinitializes the printer and forces iTherm® 280 mode
3 Reinitializes the printer and forces extended EPOS mode
4 Disables IPCL commands
5 Enables IPCL commands
6 Disables inquire processing (All command preprocessing is
disabled.)
7 Enables inquire processing
8 Enables extended diagnostics
9 Print Current Configuration
10 Not used
11 Overlays the current character chart with Group 2 OCR MA
Characters
12 Replaces the OCR characters with normal characters
13 Not used
14 Forces head maintenance
15 Print Current totals
16 Enable Test Font
17 Requests the printer to enter remote OFF.
18 Requests the printer to exit remote OFF.
20 Print alignment settings
Description The [ESC] y <n> command enables and disables command set features.
It is possible that the IPCL commands will interfere with print data. If this
occurs, the IPCL can be disabled with an [ESC] y <4> command.
Note 1: Once IPCL commands are disabled, the Enable IPLC command
will not be a valid IPCL code.
Note 2: [ESC] y <0>, <1>, <2>, and <3> allow the printer to switch
between emulation modes. When the switch takes place, the current print
buffer is printed, and the printer reinitializes. These commands do not
permanently change the configuration. A power on reset restores the
mode that was configured in menu mode. A reset by command or from
the INIT pin does not restore the mode.