Itel STL-SAT Changeover, User Manual

Page: 29 / 57

29 Control Software
© 2018 ITEL SNC
-table of alternative frequencies
The Coder menu allows you to read the entire configuration of a device (Read all) or to program an
entire device (Write all). Single features, such as alternative frequency tables, PSNs or exchange
parameters, can be read from the device or transferred to this separately by means of the "Read"
and "Write" buttons in the individual windows.
In the same menu, there are also the functions for managing the access code and updating the
firmware of the device.
3.1.1 passcode
The default access code is 0000 and is the code that the XvrProg program, as well as the device, uses at the
first start.
This code can be programmed into the device by entering the current code in the "PassCode" box and the new
code either in the "NewCode" box or in the "NewCodeConfirm" box.
Then, going to the Coder-> PassCode-> Change Coder Passcode menu, you will start the code change process,
after which the code of the device will be changed.
If you want, the new code can be saved to disk so you do not have to type it at every start of the program.
To do this, go to the Coder-> PassCode-> Save PassCode to disk menu.
3.1.1.1 Passcode on XVR file
The access code can be saved to an XVR file so that it can be sent to third parties for device
programming without them being aware of the code itself.
To save the access code along with the XVR file, simply go to the "Save Special" menu and choose
the "Save XVR file and embed current passcode" function.
The generated file will contain the encrypted access code. When loading the file, if the code entered
in this file differs from the code that the user uses by default and can be
saved to disk, will be prompted if you want to use the code contained in the XVR file or if you want to
continue using your default code.