Function
and Features
Copyright ©ITECH Electronics Co., Ltd.
19
max voltage value, the output voltage value can only be set less than the max
voltage. Our default max voltage value is the rated value.
Power-on parameters set (>P-MEN)
This item can set power on state of parameters. If you select RESET item, then
all the parameters will be initialized to the factory setting. Output voltage and
current will always be 0V/0A.Or the output value will be the same with last
power off state. The default setting is RESET item.
Power On Output State (>P-OUT)
This item can set the power on output state. If you select
keep
item, that
indicates the power on output state is the same with last power off output state.
If you select
off
item, unit will automatically in off mode when you power on.
Default setting is
OFF
item.
Communication (>COMM)
Our unit has provided three standard communication interfaces:
RS232/USB/GPIB. In this option, you can select the communication interface
according to your demands. The range of GPIB address is 0-30. Besides, we
have multi-baud rate to be chosen in RS232
mode---4800,9600,19200,38400,57600,11.52K.Data bit is 8,Check digit have
three choices: NONE, ODD, EVEN. Before you begin to carry out
communication, please make sure the configure in our unit agrees with PC
configure.
Key Sound Set (>BEEP ON)
This item can set the key sound state. If in on mode, then key sound will be
there when you press buttons. If in off mode, the beeper will not make a sound.
The default set is in on mode.
Rotary Knob Set (>KNOB)
This item is used to set rotary knob state. In on mode, you can use this rotary
knob to set the output value and overturn the menu items. In lock mode, this
knob
can’t be used. The default setting is in on mode.
External Signal Control Function (>Ext-C)
(IT6922B/IT6932B/IT6942B/IT6952B/IT6953B Specific function)
This item is used to enable or disable signal control. When OFF is selected,
function is disabled; when ANA (analog control) is selected, external analog
control function is enabled; when DIGIT (digit control) is selected, external digit
control function is enabled. The default set is in OFF option. This function will
be described in details below.
Trigger mode (>TRIG)
Before you running a list file, you need a trigger signal. Thus you must set the
