Remote Control
Copyright© Itech Electronic Co., Ltd.
9
to confirm.
GPIB address is stored in nonvolatile line storage.
1.6.4 LAN interface
The LAN interface is assembled in the rear panel of the IT6300C series power
supply. When connect PC, user can use one crossover cable to connect PC
directly. Another way is using one direct-attached network cable to connected
the router (in this case, the computer is also connected to the router).
Note
⚫
When using one crossover cable to connect PC directly, the gateway address
should be consistent with that of the PC, and the IP address should be at the same
network segment with the PC’s IP address.
⚫
When the instrument and computer are connected to the router, an independent IP
address must be assigned for the instrument.
The user can view the related information of LAN interface or configure the
communication parameters in configuration menu (Config).
View LAN Interface Information
The operation steps to view the LAN interface information are as follows.
1. Press
[Shift]+[I-set]
(
Menu
) to enter into the menu setting interface.
2. Use left/right key or rotate the knob to select
Config >
Communication
and
press
[Enter]
to confirm.
3. Use left/right key or rotate the knob to select
LAN
and press
[Enter]
to
confirm.
The first displayed menu item
Info
is to view the LAN interface information.
4. Press
[Enter]
to confirm.
5. Use the left/right key or rotate the knob to view the LAN interface
information. For details, see the information in the Config menu table of the
User Manual.
6. After the setting is completed, press
[Esc]
to exit.
Configure LAN Interface Information
The configurable parameters are described as follows.
The instrument address
IP: This value is the Internet Protocol (IP) address of the instrument. An IP
address is required for all IP and TCP/IP communications with the instrument.
An IP Address consists of 4 decimal numbers separated by periods. Each
decimal number ranges from 0 through 255 with no leading zeros (for example,
169.254.2.20).
IP Mask: This value is used to enable the instrument to determine if a client IP
address is on the same local subnet. The same numbering notation applies as
for the IP Address. When a client IP address is on a different subnet, all packets
must be sent to the Default Gateway.
Gate: This value is the IP Address of the default gateway that allows the
instrument to communicate with systems that are not on the local subnet, as
determined by the subnet mask setting. The same numbering notation applies
as for the IP Address. A value of 0.0.0.0 indicates that no default gateway is
defined.
DNS1: This field enters the primary address of the server. Contact your LAN
Enter
