100V LINE
Total impedance
100V/COM
Speaker connection:
Loosen the pressure screw.
Put the speaker cable under the wire clamp pad.
Tighten the pressure screw and make sure the
connection is good.
1.
2.
3.
NOTE:
100V output must be connected in parallel with the speakers, and should be connected
with the constant voltage speakers, constant voltage speaker is with built-in transformer,
there marked input voltage in back; if it connects with the constant resistance speakers,
it will be easy to damage the speakers .
When use the device, please do not directly touch the 100V speaker output
interface of the exposed metal parts in the rear panel to avoid electrical shock.
100V COM
41
(T-2240D)
20
(T-2500D)
28
(T-2350D)
6
. C O N N E C T I O N S
8
Speaker connections
Attention:
Connect cable with the speaker, then with the host.
Speaker Selection: Constant Voltage 100V Speaker.
Please use black and red wire for the speaker line, connect black wire to speakers
terminal; the red wire connect with speakers' 100V marked at back, the other end
connect with the" 100V "terminal in the rear panel.
Avoid to operate the amplifier in full power state for a long time.
Do not connect the two speaker wires by short circuit way, to avoid damage the
equipment.
83
(T-2120D)
Summary of Contents for T-2120D
Page 12: ...8 BLOCK DIAGRAM 10...
