Operating Instructions
■
Before operation:
1. Make sure all parts of the product are clean and rustless, and that no loose
parts exist.
2. Check that no leakage occurs while the tool is resting or while the product is
tested without cables
■
ATTENTION
！
！
！
！
Do not build up the hydraulic tool when the tool head jaws
are closed and the dies are not in place.
■
ATTENTION
！
！
！
！
Oversized fittings will not allow the tool head frame of the
tool to close completely, causing damage to the tool head frame.
■
During operation:
1.
Do NOT operate the product without the dies or a connector in place.
It
may damage the piston or tool head or the injure the operator.
2. Operation with dies in accordance with the specifications in this handbook is
required. Always keep the fitting centered on the tool die and do not use
over- specification materials.
3. Stop operating immediately in case of any abnormalities. Refer to the
Trouble- Shooting
section of this manual, if:
a) Compression of lugs cannot be implemented.
b) Dies cannot be set in place or removed.
c) Piston is stuck or unable to retract after operation.
.
■
After operation:
1. Clean the product and ensure that all pieces are in working condition.
2. Apply rust preventive oil on a regular basis.
3. Always store this tool in the case with the cylinder piston fully retracted.
KuDos Mechanical
5
