6
v081118
7
FRANÇAIS
ENGLISH
ENGLISH
FRANÇAIS
6
v081118
7
FRANÇAIS
ENGLISH
ENGLISH
FRANÇAIS
PROBLEM CAUSE
Loose screws.
O-ring is possibly worn out.
Inadequate air supply.
Inadequate lubrication.
O-rings or seal is worn
or damaged.
Loose screws.
O-ring is possibly worn out.
Incorrect fasteners
Damaged Fasteners.
Magazine or nose screws
are loose.
Magazine is dirty.
Driver is worn or damaged.
CORRECTION
Tighten the screws.
Replace damaged or worn O-ring.
Make sure air supply is adequate.
Place two or three drops of oil to the air inlet of
the tool.
Tighten the screws.
Replace damaged or worn O-ring.
Supply approved fasteners of the correct size.
Replace undamaged fasteners.
Tighten screws.
Clean magazine.
Replace damaged or worn components.
TROUBLESHOOTING
PROBLEM
Air is leaking near
the top of the tool or
the trigger area.
Tool does nothing or
operates sluggishly.
Air is leaking near the
bottom of the tool.
Tool is jamming frequently.
WARRANTY
ITC branded power tools, air nailers staplers and compressors are designed for use in
DIY (do-it-yourself), light or intermittent duty, semi-professional applications. They are not
intended for use in professional, production, industrial or continual use applications.
ITC makes every effort to ensure that its products meet high quality and durability
standards and are warranted for two years against manufacturers’ faults and defects for
a period of two years from the date of purchase to the original owner. ITC will REPAIR
OR REPLACE (at our discretion) merchandise deemed by the company to be defective,
provided that it is has not been misused, abused, altered, or repaired by anyone other than
an authorized repair centre.
Please consult the ITC catalogue or your nearest ITC distributor to determine those
products that are covered by our over-the counter warranty. Any ITC tool that fails during
normal use and within the specified warranty period and qualifies for over-the counter
warranty must be returned to its point of purchase for replacement or credit. Any item not
listed as over-the-counter warranty must be shipped, prepaid freight, to an authorized
repair depot accompanied by a copy of the invoice specifying the date that the item was
purchased. Returned tools that are not accompanied by a proof of purchase (Copy of
Invoice) will not be repaired or replaced under warranty.
This warranty does not extend to normal wear or consumable parts such as brad and
staple gun driver blades, grinding discs, saw blades, driver bits, electric motor brushes,
worn chords, etc. It also does not apply to ITC tools used in professional, production,
industrial or continual use applications.
For a listing of the authorized repair centers please refer to the ITC catalogue.
