ENGLISH
NOTE:
It is recommended to make several test cuts in scrap material to confirm
cutting depth is correct.
CUTTING IN SEVERAL PASSES (FIG. A & B)
WARNING:
Disconnect router from the power source before making any
adjustments.
It is recommended that particularly deep grooves be cut with several passes to
ensure an accurate cut and quality finish. Use these procedures as a guide only.
Things to consider when making a cut are; depth of cut, width of router bit, type of
bit and type of material being cut. As mentioned earlier in this manual, make test
cuts in similar waste materials. Perform the following procedures to get the best
results.
1. Set the final desired routing depth as instructed in the previous section.
2. Rotate the
Depth Stop Turret (9)
to the highest position under the
Depth
Stop (8)
that allows the router to make a cut.
3. Execute the first cut.
4. Leave the
Depth Stop (8)
in position. Rotate the
Depth Stop Turret (9)
to the
next lowest position and perform the next cut.
5. Again, rotate the
Depth Stop Turret (9)
to the final position to execute the last
cut.
CAUTION:
To deep a cut will lead to overloading of the motor or difficult operation.
Cutting depth should not exceed 13 mm or 1/2" at one pass. If the desired
cutting depth is greater, make several passes with the depth of cut increased
each time.
FINE ADJUSTMENT OF CUTTING DEPTH (FIG. A & B)
WARNING:
Disconnect router from the power source before making any
adjustments.
If, after setting the desired cutting depth, a small adjustment is needed, it is not
necessary to perform the entire depth setting procedure. This unit is fitted with
a
Fine Adjustment Knob (12)
in order to make minor adjustments to the cutting
depth if needed.
n
Rotating the
Fine Adjustment Knob (12)
counter-clockwise will result in a
deeper cut.
n
Rotating the
Fine Adjustment Knob (12)
clockwise will result in a shallower
cut.
SWITCHING ON AND OFF (FIG. A & B)
1. Grasp the router securely by the handles. When it is pointing in your direction,
the
On/Off Switch (1)
is located on the right handle.
2. Keeping the
Trigger lock-on button (2)
, press the
On/Off Switch (1)
. You do
not have to keep the
Trigger lock-on button (2)
pressed as it remains in
position automatically until you release the
On/Off Switch (1)
again.
. To stop the machine, simply release the
On/Off Switch (1)
and the motor will
stop.
OPERATING INSTRUCTIONS
