10
4.4.
Connection to the onboard power supply, installation of a fuse
The product's "-" power lead shall be connected to the "-" power lead of the external device. The "-" power
supply circuit of the product and the external device resulting from this connection must be connected either to the
vehicle ground or to the battery's "-" terminal (if there is a ground switch on the vehicle and it is required that the
product and the external device operate when the vehicle's ground switch is off).
Attention!!! The connection of the product's "-" power lead with the "-" power lead of the external device
must be maintained at all possible positions of the various switching elements of the electrical circuits that are
external to the product and the external device. Failure to comply with this rule may lead to failure of the prod-
uct and/or external device. The manufacturer considers violation of the specified rule of connecting the prod-
uct to an external device and the vehicle’s on-board network as a violation of the product’s operating condi-
tions and accordingly terminates its warranty.
The "+" power wire of the product must be connected to the “+” of the vehicle's on-board network through the
fuse supplied with the product. The fuse holder supplied with the product must be connected to the break of the
"+" power supply wire of the product in close proximity to the point of its connection to the vehicle's on-board
network. The product is recommended to be connected (via a fuse) to the contact or output of an external device
connected to the "+" of the vehicle’s on-board network.
Attention!!! Neither the connection of product's information inputs/outputs to the power supply circuits of
the vehicle’s on-board network, nor the supply of a reverse-polarity voltage to the product, is allowed. The man-
ufacturer regards such actions as violation of the conditions of use of the product and, accordingly, terminates
its warranty obligations as a manufacturer.
Install a fuse in the fuse holder.
The fuse supplied with the product cannot be used to connect additional external devices to the on-board net-
work (other than the product).
5.
Configuring the product
The configuration consists in the calibration of the product i.e. the compilation of a calibration table for each
specific “item-object” pair (Fig.15).
When performing calibration, disable filtering (in the “Sensor Settings” tab of the Configurator).
Summary of Contents for GS.01.00.00.000 IM
Page 3: ...3 Figure 1 Figure 2...