Italeri 2320-01-097-0248, Technical Manual

Page: 664 / 781

TM 9-2320-279-34-1
Axles No. 1 and No. 2 Maintenance Instructions (Cont)
9-2. AXLE SHAFT ASSEMBLY REMOVAL/REPAIR/INSTALLATION (CONT).
(10) Apply silicone adhesive-sealant to underside of heads
of 10 screws (6).
(11) Install 10 screws (6). Tighten screws to 185 to
190 lb-ft (251 to 257 N•m).
(12) Apply thin coat of grease to bearing and seal surfaces
of axle skein (6).
f . F o l l o w - o n M a i n t e n a n c e .
(1) Install front brakeshoes (TM 9-2320-279-20).
(2) Fill axle (LO 9-2320-279-12).
END OF TASK
9-3. AXLE NO. 1 REMOVAL/INSTALLATION.
This task covers:
a. Removal
b. Installation
c. Follow-on Maintenance
INITIAL SETUP
Models
All
Test Equipment
None
Special Tools
None
Supplies
Preventive, rust, Item 53, Appendix C
oil, lubricating, Item 46, Appendix C
Personnel Required
MOS 63W, Wheel vehicle repairer (2)
References
None
Equipment Condition
TM or Para
Condition Description
TM 9-2320-279-20 Propeller shaft removed
from No. 1 axle.
Para 9-14 Ball and bushing removed
from No. 1 axle.
TM 9-2320-279-20 Shocks removed from No. 1
axle.
Para 14-4 Lateral torque rod removed
(front only).
Special Environmental Conditions
None
General Safety Instructions
Wheels chocked.
Level of Maintenance
Direct Support
9-6