iSystem IC57163, User Manual

Page: 11 / 24

ECU14 DAP 10-pin 1.27mm Converter
Ordering code IADAP10ECU14
The ECU14 connector and the pinout has been defined by Bosch.
The ECU14 DAP 10-pin converter is connecting at the end of the 10-pin 1.27mm Infineon DAP2
Wide D. Adapter (Ordering code IC50163-2) or
Infineon DAP/DAPE Active Probe (Ordering
code IC57163) acting as a pinout converter is available for TriCore embedded targets featuring
the ECU14 10-pin 1.27mm target debug connector. It must be ordered separately.
A1
- The following pinout is valid on the target side:
Signal
Direction
Signal
Description
Signal Pin Pin Signal
Signal
Description
Signal
Direction
Ground GND 1 2 DAP0 DAP clock O
Not Connected NC 3 4 DAP2 Optional 2nd
Data pin
I/O
I/O DAP Data pin DAP1 5 6 DAPEN Optional 3rd
Data pin
I/O
Not Connected NC 7 8 Vref Reference
voltage
I
Not Connected NC 9 10 nRESET Reset O
Revision A1: 10-pin ECU14 target pinout
A2
- The following pinout is valid on the target side:
Signal
Direction
Signal
Description
Signal Pin Pin Signal
Signal
Description
Signal
Direction
Ground GND 1 2 DAP0 DAP clock O
I/O Optional 3rd
Data pin
nTRST/DAPEN 3 4 DAP2 Optional 2nd
Data pin
I/O
I/O DAP Data pin DAP1 5 6 DAPEN Optional 3rd
Data pin
I/O
Not Connected NC 7 8 Vref Reference
voltage
I
Not Connected NC 9 10 nRESET Reset O
Revision A2: 10-pin ECU14 target pinout
Signal Direction is described from the BlueBox perspective.
The pin next to the alignment pin is pin 10 and not pin 1!
Pin is marked with a number 1 directly on the converter target connector.