General information
Advices for correct and comfortable seating
Adjust the horizontal adjustment in such a way, that the pedals can be
reached easily and can be tromped without any efforts to the floor.
Adjust the backrest to an inclination that the steering wheel can be
reached also with angled arms.
The lumbar support shall avoid a hollow-back or a humpback. Take care
that your complete back abuts to the backrest from the bottom to the
shoulder.
Don't adjust the shock absorber so softly that on rough roads the seat
will knock through.
A wrong adjusted seat risks your driving safety and health.
Before driving adjust the seat optimal to your body, particularly when
changing the driver.
The seat is suitable for the operator's weight of maximum 150 kg
Don't operate several control elements at the same time.
All adjustment mechanism must engage audibly.
Move levers over the complete operation stroke to avoid wear of the
mechanism.
The seat shall not be used as ascent help.
The seat may not be blocked by objects in the vehicle (particularly the
suspended seat), otherwise the seat can be damaged.
Do not place anything on the seat and don`t cover the seat.
Inappropriate handling of seat heating, respectively wrong connection, can
lead to overheating.
When driving without passenger, take care that the seat heating of the
passenger seat are switched off.
Always use the seat belt and don`t adjust the backrest too much
backwards when driving, even for the passenger.
Fasten only one person by one belt and don´t fasten anything on the seat.
The shock absorber must be adjusted so tautly, that even when driving a
bad road, the contact to the pedals is ensured.
GB
Please read the operating instructions thoroughly before using the
ISRI seat. Become familiar with its technical features.
Keep the operating instructions within the vehicle.
The first owner is obliged, to hand out this manual to the next owner in case of selling
the truck.
Warning notes
If you don`t consider the following instruction, the liability, warranty and
possibly the general operating permit will be lost.
Breaking these rules could cause serious or fatal injury to yourself and
others:
The seat has to be installed or repaired only by workshop specialists.
In doing so the regulations of the relevant countries have to be observed.
Defective parts have to be repaired or exchanged immediately.
When the seat will be mounted and connected in the vehicle, the
guidlines of the vehicle manufaturer have to be considered.
Changings on the seat are inadmissible.
Only original spare parts have to be used.
Seat anchorages and locking mechanisms have to be checked frequently.
Don't use a damaged or faulty seat.
It is not allowed to weld broken steel parts.
A defective safety belt must be exchanged immediately and is not
allowed to be repaired.
A belt/webbing shall be regarded as defective in case of rubbing spots, rips, kinks,
squeezed or frayed, if the belt/webbing is not tight enough to the body due to bad
retraction or if the belt buckle doesn't engage properly the belt tongue or if fittings
and plastic covers are damaged or cracked.
The belt is not defective when the belt roll up apparently to slowly.
After a vehicle accident the seat must be exchanged completely.
For cleaning the seat, use only an slightly dampened cloth without strong
solvents.
The upholstery cover shall not be soaked.
Due to reasons of road safety, the seat must only be adjusted when the
vehicle is stationary and the hand brake is pulled.
7018551/Rev.26.09.2017
4
